#Ultimaker cura download 4.8 update#

It's essentially as fast as the USB connection between the pi and the printer allows. It's a lot more lightweight than Octoprint, and it's also running in virtual sd card mode, where the machine thinks it's an sd card, but the gcode is stored on the pi. While I wouldn't say I run the typical setup, I run Klipper on the pi and and front-end called fluidd. I would say that Octoprint would be more reliable for this because it's running on a really simple linux install.

#Ultimaker cura download 4.8 update#

You wouldn't want a windows 10 update to ruin a multi-day print for example. I think they said it was unstable for whatever reason, not sure.īut do you print over USB? Personally I don't like that idea because it relies on the computer being connected and also completely stable. Hm, not sure but I think that functionality was removed from Slic3r and Prusaslicer some time in 2019, so Superslicer inherited that. I strongly recommend everyone to check this before slicing any new model, or you will have the most broken results you ever saw on your printer.Īt least one other user had the same issue and you don´t want a ten hour print to result in a pile of muddled plastic. The second extruder should be '1' and the third '2' and so on unless you wired them differently. If you have more than one extruder you should check the rest, too. If there is a '1' a non existing fan will be activated during prints and your prints will melt away like chocolate in the sun. It is the last option in the nozzle settings on the left, below the nozzle offset settings.įor printers with only only one extruder this index value should be '0' as counting starts with 0. Enter the first extruder page and check the part cooling fan index. 'Printer' and 'Extruder #1' (more if you have more extruders). To fix this open Cura settings, printer section, select your printer and use the settings button in the same row.Ī new window opens with two pages. This results in disabled part cooling for any future sliced print. When updating to 4.8.0 the fan index of the part cooling fan gets altered to '1'. I mentioned this at other locations, but Cura is converting the printer settings wrong and this may be a problem for you, too.